Test print – Xerox WorkCentre M20-M20i-2723 User Manual
Page 109
Xerox WorkCentre M20i System Administration Guide
Page 7-21
Network Installation
Us
in
g In
te
rn
et
Se
rvic
es
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
¾
Select the [Status] tab and then select [Reset Network Controller] to enable the
selections to take effect.
¾
Using the procedure located in the Xerox CentreWare documentation, install the driver for
the workstation.
¾
Continue with Test Print.
Test Print
To ensure the device has been installed on the network correctly a test print should be
submitted from a client workstation. Perform the following steps:
¾
Open a document on a client workstation.
¾
Select the device as the printer to which the selected document will be sent.
¾
Print the document on the device and verify that it prints correctly.
¾
Ensure that the driver is installed on every workstation that will be sending jobs to the
device.
¾
Repeat the test for all workstations that will be sending jobs to the device.
¾
The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
7
8
9
1
2
3
4
5
6