Pioneer SC-LX82 - Manual (Page 100)

Controlling the rest of your system (In case of SC-LX72) 10
100
En
Controlling the rest of your system
(In case of SC-LX72)
Important
• This section includes explanations for the SC-LX72’s
remote control. For instructions for the SC-LX82’s
remote control, see
Controlling the rest of your
system (In case of SC-LX82) on page 93.
Operating multiple receivers
The remote control included with this receiver can be
used to operate up to three other receivers (of the same
model as this receiver) in addition to this receiver. The
receiver to be operated is switched by inputting the
preset code to set the remote control setting.
• Set the remote modes on the receivers before using
this function (see Remote Control Mode Setup on
page 127).
1 Check the operation selector switch to MAIN.
2 Press .
3 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
4 Use the number buttons to enter the 5-digit preset
code (see below).
• Receiver 1: 6 1 9 3 5 (Default)
• Receiver 2: 6 2 6 3 0
• Receiver 3: 6 2 6 3 1
• Receiver 4: 6 2 6 3 2
The LED flashes twice when the preset code has been
properly registered. When the preset code is fully input,
the LED flashes once to indicate that the setting has
failed.
To operate another receiver, start over from step 1 to
input its preset code.
Setting the remote to control other
components
Most components can be assigned to one of the input
function buttons (such as
DVD or CD) using the
component’s manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (see
Programming signals from other remote
controls on page 101).
Note
• You can cancel or exit any of the steps by pressing
. To go back a step, press RETURN.
• After ten seconds of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1 Press the input function button for the component
you want to control. 1
When assigning preset codes to TV CONTROL, press TV
CTRL here.
2 Press and hold REMOTE SETUP, then release it after
the LED flashes twice.
3 Use the number buttons to enter the 5-digit preset
code.
See
Preset code list on the separate booklet.
The LED flashes twice when the preset code has been
properly registered. When the preset code is fully input,
the LED flashes once to indicate that the setting has
failed.
INPUT
1 2 3
HDMI OUT
SLEEP MCACC
INPUT
SELECT
SIGNAL SEL
4 5 6
DIMMER A.ATT SBch
7 8 9
CLASS
MASTER
VOLUME
CH LEVEL D.ACCESS
/CLR 0 ENTER
1 3
4 5 6
7 8 9
0
2
REMOTE
SETUP
ZONE 2
MAIN
ZONE 3
AUDIO
MULTI OPE
INFO
DISP
CH
RECEIVER TV CTRL RECEIVER
REMOTE
SETUP
MAIN
RECEIVER
Note
1 You can’t assign , TUNER, HOME MEDIA GALLERY or iPod USB.
RECEIVER
RECEIVER
SC-LX82_LX72.book Page 100 Thursday, April 23, 2009 7:05 PM