Pioneer SC-LX82 - Manual (Page 59)

Listening to your system 06
59
En
Listening in surround sound
Using this receiver, you can listen to any source in
surround sound. However, the options available will
depend on your speaker setup and the type of source
you’re listening to.
If you connected surround back speakers, see also Using
surround back channel processing on page 63.
Standard surround sound
The following modes provide basic surround sound for
stereo and multichannel sources.
1
SC-LX82:
SC-LX72:
1 Set the remote control to the receiver operation
mode.
2 While listening to a source, press STANDARD
(STANDARD SURROUND). 2
If necessary, press repeatedly to select a listening mode.
With two channel sources, you can select from 3 :
• 2 Pro Logic IIx MOVIE – Up to 7.1 channel sound,
especially suited to movie sources
• 2 Pro Logic IIx MUSIC – Up to 7.1 channel sound,
especially suited to music sources
4
• 2 Pro Logic IIx GAME – Up to 7.1 channel sound,
especially suited to video games
• 2 Pro Logic – 4.1 channel surround sound (sound
from the surround speakers is mono)
• Neo:6 CINEMA – 7.1 channel sound, especially
suited to movie sources
• Neo:6 MUSIC – 7.1 channel sound, especially suited
to music sources 5
• Neural THX – Up to 7.1 channel sound, especially
suited to music sources
6
With multichannel sources, if you have connected
surround back speaker(s) and have selected
SBch ON, you
can select (according to format):
• 2 Pro Logic IIx MOVIE – See above (only available
when you’re using two surround back speakers)
• 2 Pro Logic IIx MUSIC – See above
• Dolby Digital EX – Creates surround back channel
sound for 5.1 channel sources and provides pure
decoding for 6.1 channel sources (like Dolby Digital
Surround EX)
• DTS-ES – Allows you to hear 6.1 channel playback
with DTS-ES encoded sources
• DTS Neo:6 – Allows you to hear 6.1 channel playback
with DTS encoded sources
Note
1 In modes that give 6.1 channel sound, the same signal is heard from both surround back speakers.
2 The STANDARD listening mode cannot be selected in the following cases:
– When headphones are plugged in.
– When
MULTI CH IN input is selected.
– When the HDMI audio output parameter is set to THROUGH in Setting the Audio options on page 85.
SOURCE
TV RECEIVER
VOL
VOL
TV CONTROL
CH
RECEIVER
iPod CTRL
STATUS
THX PQLS MPX
PHASE CTRL CH LEVEL
TUNE
PGM MENU
STEREO
SIGNAL SEL SLEEP AUDIO
INFO
DIMMER
A.ATT SBch MCACC
DISP
AUTO/ALC/
DIRECT STANDARD ADV SURR STANDARD
AUTO/ALC/
DIRECT
PHASE CTRL STATUS
REMOTE
SETUP
HDD PGM DVD
STANDARD STEREO
MENU
ADV SURR
THX
AUDIO
MULTI OPE
INFO
DISP
MPX PQLS
CH
RECEIVER TV CTRL
TV/DTV
STANDARD
RECEIVER
3 If surround back channel processing (page 63) is switched OFF, or the surround back speakers are set to NO (this happens automatically if
the Surround back speaker setting on page 121 is set to anything but Normal), 2 Pro Logic IIx becomes 2 Pro Logic II (5.1 channel sound).
4 When listening to 2-channel sources in Dolby Pro Logic IIx Music mode, there are three further parameters you can adjust: C.WIDTH,
DIMENSION and PANORAMA. See Setting the Audio options on page 85 to adjust them.
5 When listening to 2-channel sources in Neo:6 Cinema or Neo:6 Music mode, you can also adjust the center image effect (see Setting the Audio
options on page 85).
6 Neural THX can be selected for 2-channel signals for which the input signal is PCM (48 kHz or less), Dolby Digital, DTS or analog 2-channel
sources.
SC-LX82_LX72.book Page 59 Thursday, April 23, 2009 7:05 PM