Resetting the system, Default system settings, Using other functions 09 – Pioneer SC-LX82 User Manual
Page 92
Using other functions
09
92
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set
MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1
Switch the receiver into standby.
2
While holding down ENTER on the front panel,
press
STANDBY/ON.
The display shows
RESET
NO .
3
Select ‘RESET’ using
/, then press ENTER on
the front panel.
The display shows
RESET? OK.
4
Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting
Default
Digital Video Conversion
ON
SPEAKERS
A
Surround Back System
Normal
Speaker System
Front
SMALL
Center
SMALL
Surr
SMALL
SB
SMALLx2
SW
YES
Crossover
80 Hz
X-Curve
OFF
THX Audio Setting
1.2 m<
DIMMER
Medium bright
Inputs
See
Input function default and possible settings on page 48.
MULTI-ZONE
ZONE 2/3 Volume Level
Variable
ZONE 2/3 Volume
–60 dB
HDMI
HDMI Audio
Amp
HDMI output
HDMI OUT ALL
KURO LINK
ON
DSP
Surround back channel Processing
ON
Phase Control
ON
Full Band Phase Control
OFF
Sound Retriever
iPod/USB or HOME
MEDIA GALLERY
function
ON
Other functions
OFF
Sound Delay
0.0 frame
Dual Mono
CH1
DRC
AUTO
SACD Gain
0 dB
LFE Attenuate
0 dB
Auto delay
OFF
Up Mix
ON
Digital Safety
OFF
Effect Level
EXT.STEREO
90
Other modes
50
2 PL II Music
Options
Center Width
3
Dimension
0
Panorama
OFF
Neo:6 Options
Center Image
Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs
Listening Mode
(2 ch)
AUTO
SURROUND
Listening Mode
(x ch)
AUTO
SURROUND
Listening Mode (HP) STEREO
See also
Setting the Audio options on page 85 for other default
DSP settings.
MCACC
MCACC Position Memory
M1: MEMORY 1
Channel Level (M1 to M6)
0.0 dB
Speaker Distance (M1 to M6)
3.00 m
Standing Wave
(M1 to M6)
Standing Wave
On/Off
ON
ATT of all channels/
filters
0.0 dB
SWch Trim
0.0 dB
EQ Data (M1 to M6)
All channels/bands
0.0 dB
EQ Trim
0.0 dB
Setting
Default
SC-LX82_LX72.book Page 92 Thursday, April 23, 2009 7:05 PM