Pioneer SC-LX82 - Manual (Page 95)

Controlling the rest of your system (In case of SC-LX82) 10
95
En
6 To program additional signals for the current
component repeat steps 4 and 5.
To program signals for another component, exit and
repeat steps 1 through 5.
7 Press and hold MULTI OPERATION for a couple of
seconds to exit and store the operation(s).
Erasing one of the remote control
button settings
This erases one of the buttons you have programmed and
restores the button to the factory default.
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows
SETUP.
2 Use / to select ERASE, then press ENTER.
The LCD on the remote prompts you for the component
corresponding to the button setting to be erased.
3 Press the input function button corresponding to
the command to be erased, then press ENTER.
The LCD display flashes
PRES KEY.
4 Press and hold the button to be erased for two
seconds.
The LCD display shows
OK or NO CODE to confirm the
button has been erased.
5 Repeat step 4 to erase other buttons.
6 Press and hold MULTI OPERATION for a couple of
seconds when you’re done.
Resetting the remote control presets
This will erase all preset remote control preset codes and
programmed buttons.
1
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows
SETUP.
2 Use
/ to select RESET, then press ENTER.
RESET flashes in the LCD display.
3 Press and hold ENTER for about two seconds.
The LCD shows OK to confirm the remote presets have
been erased.
Confirming preset codes
Use this feature to check which preset code is assigned
to an input function button.
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows
SETUP.
2 Use
/ to select READ ID, then press ENTER.
The LCD on the remote prompts you for the input
function button you want to check.
3 Press the button of the component for which you
want to check the preset code, then press ENTER.
The brand name and preset code appears in the display
for three seconds.
Renaming input function names
You can customize the names that appear on the remote
LCD when you select an input function (for example, you
could change the name of
DVR to HDD/DVR).
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows
SETUP.
2 Use / to select RENAME, then press ENTER.
The LCD on the remote prompts you for the button of the
input function you want to rename.
3 Press the input function button you want to
rename then press ENTER.
4 Use / to select NAME EDT, then press ENTER.
To reset the button to its original (default) name, select
NAME RST above.
5 Edit the name of the input function in the remote
control LCD, pressing ENTER when you’re finished.
Use
/ to change the character and / to move
forward/back a position. The name can be up to eight
characters (the possible characters are listed below).
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789 \ / * + – [space]
Note
1 When Selecting preset codes directly on page 93 are set, all the signals learned in the input function buttons are cleared. This function is
convenient when you want to reset some but not all of input function buttons.
SC-LX82_LX72.book Page 95 Thursday, April 23, 2009 7:05 PM