IDEX Health & Science VS-606V7 Series - Manual (Page 56)

56
To prevent shock at machine start/stop, accel/decel can be performed in S-curve
pattern.
Note: The S-curve characteristics time is the time from accel/decel rate 0 to a reg-
ular accel/decel rate determined by the set accel/decel time.
The following time chart shows FWD/REV run switching at deceleration to a stop.
Soft-start characteristics (n023)
Setting S-curve characteristic time
0 S-curve characteristic not provided
1 0.2 second
2 0.5 second
3 1.0 second