AirLive MW-2000S - Manual (Page 11)

Chapter 3. Base Installation
AirLive MW-2000S User’s Manual 6
Chapter 3. Base Installation
3.1 Hardware Installation
3.1.1 System Requirements
y Standard 10/100BaseT including five network cables with RJ-45 connectors
y All PCs need to install the TCP/IP network protocol
3.1.2 Package Contents
The standard package of MW-2000S includes:
y
MW-2000S x 1
y CD-ROM x 1
y Quick Installation Guide x 1
y Power Adaptor (DC 5V) x 1
y Cross-over Ethernet Cable x 1
y Straight-through Ethernet Cable x 1
y Console Cable x 1
Warning: Using a power supply with different voltage rating will damage this product.
3.1.3 Panel Function Descriptions
Front Panel
LED: There are four kinds of LED, Power, Status, WAN and LAN, to indicate different status of the system.
y Status:
o For Normal Startup:
¾ Flashing: during system startup.
¾ Steady ON: to indicate the system is in “Normal Operation” modes.
o In Reset Operation:
¾ Flashing: Status LED is flashing if the Reset button is pressed for more than 3 sec and released in
less than 10 sec. When the Status LED starts flashing is the indication that the system has been
successfully reset.
¾ Steady ON: status LED will switch from flashing to steadily ON if the Reset button is pressed over
10 sec, it indicates that the system has been reset to factory default setting.
y WAN1~2/Private/LAN1~4
o Light blinking: data packets are being transmitted or received.
o Light on: linked/established Ethernet connection present.
o Light off: no existing Ethernet port connections to MW-2000S.
Wireless Mangement Gateway MW- S 2000
Status Private WAN1 WAN2 LAN1 LAN2 LAN3 LAN4 Power
Power
Status
WAN1-2 / Private / LAN1-4