AirLive MW-2000S - Manual (Page 34)

Chapter 5. Multi-Service Providers
AirLive MW-2000S User’s Manual
29
5.2 Before to start
There are several things user must pay attention, before you start to configure it:
1. The firmware version must be correct
The current firmware version of MW-2000S is 2.00.00_00900, and WLA-5000AP firmware version must be
v2.00e12, or MW-2000S will not succeed to detect WLA-5000AP.
2. WLA-5000AP must be reset with default setting
If user would like to allow MW-2000S auto-detecting WLA-5000AP, the WLA-5000AP device must be reset with
default setting, or MW-2000S will not succeed to detect WLA-5000AP.
3. Do not power off MW-2000S and WLA-5000AP during auto-configuring WLA-5000AP
When MW-2000S starts to configure WLA-5000AP, user may not power off MW-2000S or WLA-5000AP, or it could
damage WLA-5000AP, and possibly can not rescue it back even restore the boot loader.
User can follow the steps to create your own Multi-Service Providers setting:
Chapter 5.3 – Setup Internet Connection
Chapter 5.4 – Setup Service Zones
Chapter 5.5 – Setup Authentication Account
Chapter 5.6 – Setup AP Management
Chapter 5.7 – Setup Policy Configuration