AirLive MW-2000S User Manual
Page 168
Chapter 7. Web Interface Configuration
AirLive MW-2000S User’s Manual
163
y
E-mail Notification Configuration:
¾
Send To: Up to 3 e-mail address can be set up to receive the notification. These are the receiver’s e-mail
addresses. There are four kinds of notification to selection -- Monitor IP Report, Traffic History, On-demand
User Log and AP Status, and check which type of notification to be sent.
¾
Interval: The time interval to send the e-mail report.
¾
Send Test Email: To test the settings immediately.
¾
Send From: The e-mail address of the administrator in charge of the monitoring. This will show up as the
sender’s e-mail.
¾
SMTP: The IP address of the sender’s SMTP server.
¾
Auth Method: The system provides four authentication methods, Plain, Login, CRAM-MD5 and NTLMv1,
or “None” to use none of the above. Depending on which authentication method selected, enter the
Account Name, Password and Domain.
o NTLMv1 is not currently available for general use.
o Plain and CRAM-MD5 are standardized authentication mechanisms while Login and NTLMv1 are
Microsoft proprietary mechanisms. Only Plain and Login can use the UNIX login password.
Netscape uses Plain. Outlook and Outlook express use Login as default, although they can be set
to use NTLMv1.
o Pegasus
uses
CRAM-MD5 or Login but which method to be used can not be configured.
y
Syslog Configuration: There are 2 types of Syslog supported: System Log and On-demand User Log. Enter
the IP address and Port number to specify which and from where the report should be sent to.
Note: When the number of a user’s session (TCP and UDP) reaches the session limit specified in the policy, a
record will be logged to this Syslog server.
y
FTP Server Settings
¾
Session Log: Log each connection created by users and tracking the source IP and destination IP. If
Syslog is enabled, Session Log will be sent to the Syslog server automatically during every defined interval
in Session Log email notification. Session Log allows uploading the log file to a FTP server periodically. The
maximum log file size is 256K. The log file will be sent to the FTP server once the file size reaches its
maximum size or periodical time interval.