CCTV Camera Pros Geovision 8.4 Multicam Digital Surveillance System - Manual (Page 433)

Remote Viewing
417
8
8.7.3 Receiving Multicast and Audio Broadcast
To remotely receive multicast and audio broadcast, there are three methods: use the multicast
program included on the software DVD, through the web interface of WebCam server, and through the
Multi View of WebCam server.
Using Multicast Program on Software DVD
1. Install and run Multicast from the Surveillance System Software DVD. This dialog box appears.
Figure 8-48
2. The host(s), using the same multicast IP address within the same LAN, is displayed automatically
on the host list. If you cannot see any host displayed, click the Configure button, select General
Setup, and ensure the relevant IP address and port number are correctly configured.
3. Drag the desired cameras to the screen for display. If the host has already set a password, you will
be promoted to enter it at this step.
4. To receive audio broadcast, first ensure a speaker is properly installed on this computer. Click the
Configure button, select General Setup, select Receive Broadcast Audio, and ensure the
broadcast IP address and port number are correctly configured, and click OK.
5. To save the current settings of screen division and camera display for future use, click the
Configure button, select Video List Setup, and select Export. You can also select Import to
apply the pre-defined settings.
Host List
Configure Button