ElmoMC SimplIQ Digital Servo Drives-Solo Guitar ABS Installation Guide - Manual (Page 15)

Solo Guitar Absolute Feedback Installation Guide
MAN-SOLGUIABSIG (Ver. 1.403)
www.elmomc.com
15
3. Installation
The Solo Guitar Absolute Feedback must be installed in a suitable environment and properly
connected to its voltage supplies and the motor.
1.10. Site Requirements
You can guarantee the safe operation of the Solo Guitar Absolute Feedback by ensuring that it
is installed in an appropriate environment.
Feature Value
Ambient operating temperature 0 °C to 40 °C (32 °F to 104 °F)
Maximum relative humidity 90% non-condensing
Operating area atmosphere No flammable gases or vapors permitted in area
Models for extended environmental conditions are available.
Caution:
The Solo Guitar Absolute Feedback dissipates its heat by convection. The
maximum operating ambient temperature of 0 °C to 40 °C (32 °F to 104 °F)
must not be exceeded.
1.11. Unpacking the Drive Components
Before you begin working with the Solo Guitar Absolute Feedback, verify that you have all of its
components, as follows:
 The Solo Guitar Absolute Feedback servo drive
 The Composer software and software manual
The Solo Guitar Absolute Feedback is shipped in a cardboard box with Styrofoam protection.
To unpack the Solo Guitar Absolute Feedback:
Carefully remove the servo drive from the box and the Styrofoam.
Check the drive to ensure that there is no visible damage to the instrument. If any damage has
occurred, report it immediately to the carrier that delivered your drive.
To ensure that the Solo Guitar Absolute Feedback you have unpacked is the appropriate type
for your requirements, locate the part number sticker on the side of the Solo Guitar
Absolute Feedback. It looks like this: