ElmoMC ExtrIQ Digital Servo Drives-Eagle HV - Manual (Page 50)

Eagle HV Installation Guide Installation
MAN-EAG-HVIG (Ver. 1.502)
www.elmomc.com
50
3.5.8.2. Differential Auxiliary Encoder Input Option on Feedback B (YA[4]=2)
The Eagle HV can be used as a slave by receiving the position of the master encoder data (on
Port B1) in Follower or ECAM mode. In this mode Port B2 provides differential buffered
auxiliary outputs for the next slave axis in follower or ECAM mode.
Below are the signals on the Auxiliary Feedback port when set up to run as a differential
auxiliary encoder input:
Port Pin Signal Function Pin Positions
B1 1 CHA Auxiliary channel A high input
15-Pin High Density D-
Sub Plug
B1 2 CHA- Auxiliary channel A low input
B1 3 CHB Auxiliary channel B high input
B1 4 CHB- Auxiliary channel B low input
B1 5 INDEX Auxiliary Index high input
B2 6 CHAO Buffered channel A output
B2 7 CHAO- Buffered channel A complement output
PWR 8 +5V Encoder supply voltage
PWR 9 SUPRET Encoder supply voltage return
5
15
10
1
11
6
Port B1
Port B2
Power
15-Pin High Density
D-Sub Socket
B1 10 INDEX- Auxiliary Index low input
B2 11 CHBO Buffered channel B output
B2 12 CHBO- Buffered channel B complement output
B2 13 INDEXO Buffered Index output
B2 14 INDEXO- Buffered Index complement output
PWR 15 SUPRET Supply return
Table 12: Differential Auxiliary Encoder Input Option on Aux. Feedback
Pin Assignments
AUX. FEEDBACK on the Eagle HV has a 15-pin high density D-Sub socket. Connect the Auxiliary
Feedback cable from the feedback device to AUX. FEEDBACK using a 15-pin, high density D-Sub
plug with a metal housing. When assembling the Auxiliary Feedback cable, follow the
instructions in Section 3.5.5 (Feedback and Control Cable Assemblies).