K==oéãçíé=`зенкзд – Barco DCS-200 User Manual
Page 133
DCS-200 • User’s Guide
133
_K==oÉãçíÉ=`зенкзд
DCS-200 Command List
System Commands
Auto Input Configuration Mode
Auto Input Settings Save
Auto Take Mode
Set whether going to black is a direct cut or setup for a take
Set menu context
Perform a system diagnostic test
Display the results of the last performed system diagnostic test
Query only command for the input status type and format.
Clear the selected log (ram copy, not flash)
Display the current log messages
Set the mode for the selected log
Set the time interval for writing the enabled logs to flash
Control the lockout mode of the front panel
Query only command for the output status type and format
Query only command for the input, key and black button status on preview
Query only command for the input, key and black button status on program
Reset unit
System Save
Sets the serial port
Query only command for the temperature of the unit
Set transition time
Display Version info
Set VFD brightness
Key Commands
Luminance Key definition
LOGO Commands
Delete the selected logo file
Save the image on Program to the selected logo fame store and file
Logo selection
The logo format status. This command is a query only.
Table B-3. DCS-200 Remote Commands (Continued)
Command
Description
Page