Dcs-200 rear panel, A`pjomm=oй~к=m~åéä, Hardware orientation – Barco DCS-200 User Manual
Page 25
DCS-200 • User’s Guide
25
2. Hardware Orientation
DCS-200 Rear Panel
a`pJOMM=oЙ~к=m~åÉä
The figure below illustrates the DCS-200 rear panel:
Figure 2-1. DCS-200 Rear Panel
Following are descriptions of each rear panel connector:
1)
Analog Inputs
Six HD-15 connectors are provided for the system’s Analog inputs. Please note:
~
Each input provides 10-bits/color sampling at a maximum 165 MHz.
~
Each input supports 1:1 sampling up to 1600x1200@60 Hz. Sources
with native pixel rates greater than 165 MHz will be filtered and
undersampled at 165 Mhz. These include:
•
1920x1080p@60 (173.0 MHz)
•
1920x1200@60 (193.25 MHz)
•
2048x1080p@60 (183.75 MHz)
~
Composite and S-Video formats are supported.
In Chapter 3, refer to the “
table of analog inputs that you can connect using a customer-supplied breakout
cable. In Appendix A, refer to the “
” section on
page 118 for pinouts.
2) DVI and Analog Inputs
Two DVI-I connectors are provided for both digital and analog inputs.
~
Using the connector’s digital pins, an 8-bit digital input is supported.
~
Using the connector’s analog pins, RGBHV, analog composite, S-Video,
and YUV formats are supported. A customer-supplied breakout cable or
DVI to HD-15 adapter is required for these connections.
In Appendix A, refer to the “
” section on page 119 for pinouts.
100 - 240 VAC
50 – 60 Hz, 1.9A
ETHERNET
Model
DCS-200
SERIAL
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Input 8
HD/SD SDI
VIDEO INPUTS
MAIN OUTPUTS
PREVIEW OUTPUTS
3
7
1
2
4
5
6
8
1)
4)
7)
2)
5)
8)
3)
6)
Ethernet