Barco DCS-200 - Manual (Page 48)

48 DCS-200 • User’s Guide
4. Operation
Using the Setup Menu
Following are descriptions of each Output Menu function:
• Output Format
• Test Pattern
• Sync Setup
• Gamma
• Save Output Config
lìíéìí=cçêã~í
From the Output Menu, select the top Output Format line to view or change the current
output format. This line indicates the format in the following form:
Hact x Vact @ Vr Hz
The output format for the DCS-200 can be set to any of the progressive outputs in the
format table. In Appendix A, refer to the “
Format Table ” section on page 122 for details.
qÉëí=m~ннЙке
From the Output Menu, select Test Pattern to display the Test Patterns Menu:
Figure 4-13. Test Patterns Menu (sample)
The following functions are available on the menu:
• Mode — This function enables or disables the test pattern generator.
• Type — This function enables you to select a test pattern. Available choices are:
Note The output format is not updated until SEL is pressed.
T E S T P A T T E R N S
> M o d e
O N
T y p e B u r s t
R a s t e r B o x O F F
~ H Ramp
~ V Ramp
~ 100% Col Bars
~ 75% Col bars
~ 16 x 16 Grid
~ 32 x 32 Grid
~ Burst
~ 50% Gray
~ Gray Steps 1
~ Gray Steps 2
~ Red
~ Green
~ Blue
~ White
~ Black