Barco DCS-200 - Manual (Page 56)

56 DCS-200 • User’s Guide
4. Operation
Using the Setup Menu
those changes on the Preview source — while the Program source remains unchanged.
Figure 4-23. Adjust On Field
If both paths are using the same input source, only the selected path is modified.
When LOGO is the input for the Adjust On selection, all the Input Menu values except
Adjust On are bracketed.
qóéÉ
In the Input Menu, the Type field shows the currently selected input type, and enables you
to change the type if required. The available types depend on the selected input:
• For inputs 1 - 6: CVBS, Y/C, YPBPR, RGB/HD-YUV
• For inputs 7 - 8 (when Digital): DVI
• For inputs 7 - 8 (when Analog): CVBS, Y/C, YPBPR, RGB/HD-YUV
• For the SDI input: [SDI]
`здзклй~ЕЙ
From the Input Menu, select Colorspace to change the color space for the selected input
on Program. Values depend on the selected input. Please note:
• The default selection for YP
b
P
r
or YUV is SMPTE. In Appendix A, refer to the
“ Format Table ” on page 122 for information on the formats that are RGB, SMPTE
or both. When both formats are listed, the first item in the list is the default.
• The Colorspace Menu allows selection between these two values when the input
is analog (excluding CVBS, Y/C) or DVI.
• When either the CVBS or Y/C input is selected, only [SMPTE] is shown.
• When the following formats are detected as either SD-SDI or HD-SDI, only
[SMPTE] is shown.
I N P U T
1 0 2 4 x 7 6 8 @ 5 9 . 9 4
> A d j u s t O n P r e v i e w
Note T he SDI input always shows its type in brackets (e.g., [SDI]),
given that this input type cannot be changed.
~ NTSC (480i)
~ PAL (576i)
~ 1280x720p @50
~ 1280x720p @59.94
~ 1280x720p @60
~ 1920x1080p @23.98
~ 1920x1080p @24
~ 1920x1080p @25
~ 1920x1080p @29.97
~ 1920x1080p @30
~ [email protected]
~ 1920x1080sF@24
~ 1920x1080i @50
~ 1920x1080i @59.94
~ 1920x1080i @60