EZWatch Pro 3.1 - Manual (Page 149)

149
Software Set-Up
1. When the connections are complete, start your computer.
2. When the computer starts up, you will get the hardware wizard
saying that it has found new hardware. On some systems, you can
go through the wizard and install the hardware automatically. On
other systems you will need to point the wizard to the C:/HSDEVICE
folder for the ser2pl.sys file.
3. After the hardware wizard installs the device you will need to make
note of which com port is uses. Right click on My Computer and then
click on properties. Go to the hardware tab and then to Device
Manager.
From the Device Manager,
you will need to click on Ports
(COM & LPT)
Provided the USB device is
installed properly, you
should and item that says
Prolific USB-to-Serial com
Port. Make note of which port
number it uses since you will
need this for the next step