EZWatch Pro 3.1 - Manual (Page 18)

18
2-2. Installation Prerequisites
Make sure you install the EZWatch Pro software before you install the capture
card(s) in the PC.
2-3. Installing EZWatch Pro 3.1 HD Software
Depending on the video capture card you are using, follow the steps below to
install EZWatch Pro 3.1HD onto your computer. Precede to the step below that
matches the Capture Cards model number. The model number is displayed on a
white sticker on the back of the capture card.
GO TO STEP #1 for Capture Card CP-1400-AS
GO TO STEP #2 for Capture Card CP-3404HS
GO TO STEP #3 for Capture Card CP-1416ASE or CP-3416ASE
Note: It is necessary to install the EZWatch Pro 3.1 software first and then install
the video capture cards. If the computer has anti-virus software running it must
be turned off before you install. After installation, it can be reactivated.
Step 1: (For board #CP-1400AS)
1a. Insert the EZWatch Pro 3.1HD CD into
your CD-ROM drive, the EZWatch Pro
3.1HD installer will appear automatically
within 30 seconds listing all the available
software. Select "EZ Watch Pro 3.1 HD
1400AS". If the EZWatch Pro 3.1HD
installer does not appear on the screen
automatically, click "Start", then "Run" and
execute “d:\setup.exe” or w hatever drive
letter pertains to your CD-ROM drive.
1b. C lick next on the “W elcom e to the
InstallShield Wizard for EZWatch Pro 3.1