EZWatch Pro 3.1 User Manual
Page 27
27
C. Display Properties: You need to make sure the correct settings are enabled
before you run EZWatch Pro 3.1 HD. Your computer may or may not already have
these settings in place. Follow the steps below to ensure the correct display
settings are enabled on your computer.
Step #1: C lick “S tart”, go to “C ontrol Panel”. In the Control Panel, choose
“A ppearance and Them es”, and then choose “D isplay”. This w ill pop up the
“D isplay Properties” w indow .
Step #2a: C lick on the “S ettings” tab, tow ards the bottom you w ill see
“S creen R esolution”. This needs to be on either 800x600 or 1024x768 for
optim al resolution. You should also see “C olor Q uality”, this needs to be on
the highest setting that your VGA card will allow. EZWatch Pro 3.1 HD will
only run in 24bit color quality or higher. S o, if your V G A card w on’t support
at least 24bit color quality, then you will need to use another VGA card that
will support at least 24bit color quality.
Step #2b: Screen Saver. C lick on the “S creen S aver” tab, and tow ards
the bottom you will see the Screen Saver Section. Here you will need to
use the drop dow n m enu and choose “N one” so that there is no screen
saver that will automatically come on after a period of inactivity.
Step #3: Please select “A pply” at the bottom ... you will see your screen go
black for a short period. C lick “O k” to save all your settings.
For any technical information or if you need technical assistance, please call our
toll free technical support line at 866-241-3400 extension 106 or you can email us
at
Our sales and technical support department is open Mon-Fri, 6:00a.m.To 6:00
p.m. Mountain Standard Time. We thank you for purchase, and will continue to do
our very best to assist you in any future needs that may arise.
Windows XP is now ready to run EZWatch Pro 3.1 HD.
Installation is Complete