EZWatch Pro 3.1 - Manual (Page 153)

153
4. S im ply click on PD A V iew Pro on your PD A’s m enu and launch the
program.
5. You will see a screen below:
6. In the lower left hand corner you will see a two
computer icon. Click on to proceed to the next
screen.
7. Here you will input all the connection information.
The information has to be the same as it is on the
server.
Site Name: Allows you to name the Server that you are trying to
connect to.
IP Address: Is the IP address or Hostname of the server running
EZWatch Pro.
Port: Is the port number the PDA will connect through. If you have
not changed this number on the server then the default is ok but if
you have changed it on the server then you will need to put in that
number here.
User Name & Password: Is the user name and password which you
set up on the server. They must be exactly as you have set it up on
the server or the system will not allow access. Remember they are
case sensitive.
Quality: Is the quality of the pictures you will be viewing. The better
the quality, the slower the refresh rate. So keep this in mind when
attempting to connect.
Once you have inputted all of the required information, click on the
“C onnect” button and you w ill be connected to the EZWatch Pro
3.1HD server.