Frame assembly (11’ through 27’ models), Frame assembly (30’ through 41’ models) – Landoll 855 Series Finisholl User Manual
Page 37
ASSEMBLY INSTRUCTIONS
3-3
Frame Assembly (11’ Through
27’ Models)
1.
No assembly is needed for the 850/855 Series
Finisholl frame. However, it needs to be placed on
stands approximately 36" high in an open level area.
If your Finisholl is equipped with frame extensions,
see “Wings and Extensions Installation” on
page 3-6 for proper installation procedures.
WARNING
Frame Assembly (30’ Through
41’ Models)
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
IMPORTANT
See Figure 3-1 for part names.
1.
Place frame halves on stands approximately 36"
high.
2.
Bolt frame halves together using 3/4-10 X 2-1/2
screws and lock nuts (See Figure 3-1.)
WARNING
Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.