Landoll 855 Series Finisholl - Manual (Page 80)

4-4 F-133-0512 Edition
OPERATION AND MAINTENANCE
4. Set the unit working depth.
a. To adjust the depth, lower unit to the ground and
completely retract the lift cylinders.
b. Screw the adjustment rod in to decrease the
working depth, out to increase the working depth.
(See Figure 4-3.)
Figure 4-3: Adjusting Unit Working Depth

CAUTION
IMPORTANT
It may be necessary to adjust the wings different
than the main frame for the unit to operate level.
5. Always lift the Finisholl completely out of the ground
before turning or backing. This prevents shank or
disc damage or damage to their respective mounting
brackets.
6. Reduce speed at field ends, and lift the Finisholl
completely out of the ground before turning.
7. After a few hours of operation, check all bolts for
tightness, especially the shank U-bolts and pivot
bolts. Tighten wheel lug bolts to 90 ft.-lbs. of torque.
Tighten any loose bolts to the torques shown in
Table 2-1 and Table 2-2.
ADJUSTMENT ROD
The two adjustment rods on the main frame must
be adjusted equally or permanent equipment
damage will result.