Landoll 855 Series Finisholl - Manual (Page 69)

ASSEMBLY INSTRUCTIONS
3-35
Leveling Assembly Installation
IMPORTANT
See Figure 3-25 for part names.
1. Install the spring bushing in the pivot block.
2. Lightly coat the threads of the 1"-8 X 4 screws with
loctite. Use the screws, flat washers and split lock
washers to secure the pivot block bushings and the
pivot block between the arms extending from the
gauge wheel rockshaft.
3. Assemble the pivot bracket on the front bolt and
bushing in the mast with the short arm up and
forward as per decal on bracket. Failure to do so will
cause damage.
4. Slide a leveling spring onto the threaded end of the
leveling rod.
5. Slide the leveling rod into the pivot block and pin to
the pivot bracket with a pin and 3/8-16 X 3-1/2 screw
and lock nut.
6. Install a washer, leveling spring, washer, nut and jam
nut on the leveling rod. Thread the nut completely
onto the leveling rod and lock with a jam nut.
7. Install the radius rod between the pull hitch and the
upper end of the pivot bracket with pins, cotter pins
and a 3/8-16 X 3-1/2 screw and lock nut.