Troubleshooting guide – Landoll 855 Series Finisholl User Manual
Page 88
5-2
F-133-0512 Edition
TROUBLESHOOTING GUIDE
SHANKS PLUG WITH RESIDUE
Disc set too shallow
Increase depth of disc gangs. Disc should
run deep enough to cut residue.
Shanks not placed correctly
Check shank placement chart and adjust
shanks as required.
DISC SCRAPER SPRINGS BEND
Soil build-up on disc blades
Scrapers are too loose to clean disc
blades. Adjust scrapers tight enough to
clean disc blades.
Scrapers not in full contact with disc
Loosen two bolts in scraper blades and
rotate scraper forward or backward to
get full contact between scraper and
disc blade.
SHANK SPRINGS BREAKING
Spring pivot bolt too tight
Spring pivot bolt must be loose enough to
allow spring plug to pivot so spring is
not forced to bend.
WINGS FOLDING TOO FAST
Restrictor elbows not installed
Check to make sure restrictors are
installed per assembly instructions.
Idle tractor when folding.
Turn tractor hydraulic flow down.
Engage hydraulic valve. Hold fully
engaged until folded.
PROBLEM
PROBABLE CAUSE
SOLUTION