Landoll 855 Series Finisholl - Manual (Page 55)

ASSEMBLY INSTRUCTIONS
3-21
6. On 30’ through 35' units:
a. Install the fold cylinder bracket on the frame with
U-bolts and lock nuts (See Figure 3-10.)
b. Install base end of 5 X 24 fold cylinders to fold
bracket on frame with ports up. Pin rod end of
cylinder to bracket on wings using extended pin,
washers and cotter pins (See Figure 3-9.)
c. Install manifold to bracket on frame using 1/2-13
X 3-1/2 screws and nuts (See Figure 3-10.)
d. Install a restrictor O-ring elbow in each port of
the fold cylinders (See Figure 3-14.)
e. Install an O-ring elbow in each port of the lift
cylinders (See Figure 3-14.)
f. Install fittings in the manifold per Figure 3-14.
g. Install hoses per Figure 3-14 for the size of unit
assembled. Refer to Table 3-2 for 30' -35' model
hose lengths.
7. On 41' units:
a. Install both fold cylinder brackets on the frame
with U-bolts and lock nuts (See Figure 3-10.)
b. Install base end of 5 X 24 fold cylinders to fold
bracket on frame with ports up. Pin rod end of
cylinder to bracket on inner wings using
extended pin, washers and cotter pins (See
Figure 3-9.)
c. Install base end of 3-1/2 x 16 fold cylinders to
fold brackets on inner wing with ports up. Pin rod
end of each cylinder to top hole of wing fold
brackets using a pivot bolt, flat washer, wing
extension roller, and hex lock nut.
d. Install 18 hose manifold to bracket on frame
using 1/2-13 X 3-1/2 screws and nuts (See
Figures 3-15 and 3-16.)
e. Install both 8 hose manifolds to brackets on the
inner wing using 1/2-13 X 3-1/2 screws and nuts
(See Figure 3-16.)
f. Install a restrictor O-ring elbow in each port of
the fold cylinders (See Figure 3-16.)
g. Install an O-ring elbow in each port of the lift
cylinders (See Figure 3-15.)
h. Install fittings in the manifold (See Figures 3-15
and 3-16.)
i. Install hoses per Figures 3-15 and 3-16. Refer
to Table 3-3 for hose lengths.