Shank installation – Landoll 855 Series Finisholl User Manual
Page 57
ASSEMBLY INSTRUCTIONS
3-23
Shank Installation
1.
Mark shank locations per the shank placement
drawing for your size unit (See Figures 2-1 through
2-24.)
2.
Install shanks and clamps (See Figure 3-17.)
a.
Spring clamp assembly - Install clamp assembly
to frame using U-bolt and serrated flange nuts.
Install shank in clamp using 5/8-11X 1-3/4 screw
and flange lock nut provided. To facilitate
installation of the U-bolt nuts, remove the screw
at the top of the spring and swing the spring out
of the way.
b.
S-shank assembly - Clamp shank to frame with
two plates, two 3/8-16 X 5 screws and one 5/8-11
X 5 bolt and nuts provided.
c.
C-spring assembly - Install C-spring on frame
with clamp, bracket, 3/8-16 x 3-1/2 carriage bolt,
1/2-13 X 6 screws, and nuts provided. Install
shank in C-spring using 5/8-11 X 2 screw and
flange lock nut provided.
3.
Install sweep on shank with 7/16-14 X 1-1/2 screws,
washers and nuts provided.