Landoll 855 Series Finisholl - Manual (Page 40)

3-6 F-133-0512 Edition
ASSEMBLY INSTRUCTIONS
Wings and Extensions
Installation
1. On 11’ units, install short (bolt on) shank extensions
on rear corners of frame using 5/8-11 X 2 screws and
lock nuts (See Figure 3-3.)
2. On 14’ units, install short (bolt on) shank extensions
on rear corners of frame using 5/8-11 X 2 screws and
lock nuts. Install clamp on extensions on side rails
using u-bolts and lock nuts provided (See
Figure 3-3.)
3. On 17’ to 35’ units, install wings using hinge pins,
washers and cotter pins provided (See Figure 3-4.)
4. On 33’ (narrow frame) and 35’ units, install wing
extensions on wings using u-bolt and nuts provided
(See Figure 3-4.)
5. On 41' units:
a. Install inner wings to the frame using hinge pins,
washers and cotter pins provided (See
Figure 3-5.)
b. Install outer wings to inner wings using lower
radius rod pins, flat washers, and cotter pins in
the top hole of the double fold hinge weldments
(See Figure 3-5.)
c. Install the wing fold brackets to the front and rear
double fold hinge weldments using hinge pivot
bolt, flat washer, and hex lock nut through the
lower hole of each.
d. The cylinders will be connected to the upper hole
of the wing fold brackets later in the assembly.
Figure 3-3: Short Shank Extensions (11’ and 14’ Models)
2ma410-011258
U-BOLTS
1/2-13 HEX
LOCK NUT
CLAMP-ON EXTENSIONS
(14’ ONLY)
5/8-11 X 2 HEX HEAD CAP SCREW
FRAME
5/8-11 HEX
LOCK NUT
SHORT SHANK
EXTENSION
(11’ AND 14’ ONLY)