Landoll 855 Series Finisholl - Manual (Page 39)

ASSEMBLY INSTRUCTIONS
3-5
Rockshaft Installation, Frame
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
IMPORTANT
See Figure 3-2 for part names.
1. Install frame rockshaft, using bearing blocks, 5/8-11
X 8-1/2 screws, washers, shims, and lock nuts. The
bearing half with the grease zerk in the side goes on
top of the rockshaft with zerk to outside. Use only
enough shims between bearing halves to allow
rockshaft to rotate without binding (See Figure 3-2.)
2. When installing the rockshaft on 30’ through 41’
models, assemble the three sections of the rockshaft
with 3/4-10 X 2-1/2 screws and lock nuts before
installing in frame. Align rockshaft arms with each
other before tightening screws (See Figure 3-2.)
3. Mount the tires on the wheels and install on the hubs.
4. Recommended tires:
— 11’ through 27’ frame 9.5L X 15 8 ply
— 30’ through 35’ frame 11L X 15 10 ply
or
12.5 X 15 12 ply
— 41' frame 12.5 X 15 12 ply