Landoll 855 Series Finisholl - Manual (Page 63)

ASSEMBLY INSTRUCTIONS
3-29
5. If hydraulically adjusted double fold (41' model),
install cylinders per Figures 3-21 and 3-22.
a. Install the master cylinder on the left outer wing.
Pin the base end of the cylinder to the bracket on
the outer wing and the rod end to the arm on the
disc rockshaft.
b. Install the slave 1 cylinder on the right outer
wing. Pin the base end of the cylinder to the
bracket on the outer wing and the rod end to the
arm on the disc rockshaft.
c. Install the slave 2 cylinder on the right inner wing.
Pin the base end of the cylinder to the bracket on
the inner wing and the rod end to the arm on the
disc rockshaft.
d. Install the slave 3 cylinder on the right side of the
main frame. Pin the base end of the cylinder to
the bracket on the frame and the rod end to the
arm on the disc rockshaft.
e. Install the slave 4 cylinder on the left side of the
main frame. Pin the base end of the cylinder to
the bracket on the frame and the rod end to the
arm on the disc rockshaft.
f. Install the slave 5 cylinder on the left inner wing.
Pin the base end of the cylinder to the bracket on
the inner wing and the rod end to the arm on the
disc rockshaft.
g. With the cylinders fully extended, adjust the
screw adjust on the wing disc rockshafts until the
wing discs are to the same depth below the
frame as the discs on the main frame.
h. Install a 90° elbow in the ports of each cylinder.
i. Install hoses as shown on the shank placement
drawing for your size of machine.
6. Install depth gauge as shown in Figure 3-20.
IMPORTANT
Depth gauge should be mounted on inside bearing
block on main frame.