Figure 4-2: transport locks, Attaching to the tractor, Field operation – Landoll 855 Series Finisholl User Manual
Page 79: Caution
OPERATION AND MAINTENANCE
4-3
Figure 4-2: Transport Locks
Attaching to the Tractor
1.
Align the tractor drawbar with the machine. Raise or
lower the Finisholl ring hitch, as needed, using the
swivel jack. Attach the unit with proper size hitch pin.
2.
Clean all hydraulic couplings and attach to the
tractor. When properly attached, the hydraulic control
lever should cause the Finisholl to:
a.
Lower to the ground when the control arm is
moved forward or downward, and
b.
Raise when the control arm is moved backward
or upward.
3.
Fully extend the hydraulic gauge wheel cylinders,
and place the cylinder lockouts in the transport lock
position over the cylinder rods. Secure the lockouts
with the lockout pins (See Figure 4-2.)
4.
Always place the swivel jack on the interior mount
before setting the machine in motion.
Field Operation
1.
Raise the unit to take the weight off of the transport
locks. Remove the transport locks from the lift
cylinders (on the main frame only). Store the
transport locks on the front hinge brackets (See
Figure 4-2.)
2.
Remove the wing lock pins and store in the extra
hole in the hinge bracket. Unfold the wings and
extend the fold cylinders completely (See
Figure 4-2.)
CAUTION
3.
Check the front to rear leveling of the frame. Adjust
radius rod until frame is level at working depth and
lock it with the jam nut.
2m410-011269
HAIR PIN
ROLL PIN
WING LOCK PIN
WING
FRAME
WING LOCK PIN
TRANSPORT
LOCK
PIN
ROLL PIN
HAIR PIN
FRAME
WING
RIGHT SIDE
(WING UP)
LEFT SIDE
(WING DOWN)
Failure to remove wing lock pins before unfolding
wings will cause permanent equipment damage.