Rockshaft installation, wings, Figure 3-6: gauge wheel installation, Figure 3-7: rockshaft installation, wings – Landoll 855 Series Finisholl User Manual
Page 43
ASSEMBLY INSTRUCTIONS
3-9
Rockshaft Installation, Wings
Figure 3-6: Gauge Wheel Installation
1.
To install the gauge wheel clamp on 17’ units, fasten
the gauge wheel clamp to the outer tube of the wing
using U-bolts and nuts provided. Slide spindle
assembly into place and pin at desired depth (See
Figure 3-6.)
2.
Install short rockshafts on wings using bearing
blocks, 5/8-11 X 8-1/2 screws, washers, shims and
lock nuts. Install the bearing half with the grease zerk
in the side on top of the rockshaft. Use only enough
shims between bearing halves to allow rockshaft to
rotate without binding (See Figure 3-7.)
IMPORTANT
On 19’ units position gauge wheels with spindle
pointing outward. On 22’ units position gauge wheels
with spindle pointing inward. 25’ and larger units use
walking beams.
3.
Mount tires on the wheels and install on hubs.
4.
Recommended tires:
— 17’ wings
7.60 X 15 6 ply
— 19’ through 41’ wings
9.5L X 15 8 ply
Figure 3-7: Rockshaft Installation, Wings
GAUGE WHEEL
CLAMP
RIGID GAUGE
WHEEL PIN
U-BOLT
SPINDLE
ASSEMBLY
1/2-13 HEX
NUT
3/16 HAIRPIN
CLIP
2m410-011260a
WING
WING ROCKSHAFT
5/8-11 X 8-1/2 HEX
HEAD CAP SCREW
BEARING BLOCK
SHIM
5/8 FLAT WASHER
5/8-11 HEX
LOCK NUT
2m410-011260b