Landoll 855 Series Finisholl - Manual (Page 71)

ASSEMBLY INSTRUCTIONS
3-37
Optional Hydraulic Radius Rod
IMPORTANT
See Figure 3-26 for part names.
1. Remove the clevis from the cylinder rod, apply loctite
to the threads, and assemble the cylinder to the
radius rod.
2. Remove the nuts from the two tie screws on the left
side of the cylinder on the rod end and install the
gauge bracket.
3. Install the 1-1/4” O.D. bushing inside the 1-5/8” O.D.
bushing in the upper end of the pivot bracket.
4. Install the base end of the cylinder to the upper end
of the pivot bracket.
5. Install the adjustable end of the radius rod to the pull
hitch with the pin and cotter pins.