Landoll 855 Series Finisholl - Manual (Page 73)

ASSEMBLY INSTRUCTIONS
3-39
Warning Lights Installation
1. Assemble lights to the light bracket using 1/4 X 1-3/4
cap screws and nuts. Insure the wires are in the
groove in the base of the light toward the mounting
surface on the bracket. Assemble one light for left
side and one for right side. The red light should be to
the rear with the amber light being the outer most
light.
2. Install the assembled lights on the outside of the
frame just forward of the rear hinge using bar and
1/2-13 x 3-1/4 and 3-1/2 cap screws (4-1/2” long
screws used on 30’ - 41’ models) and nuts. (See
Figure 3-27.)
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
3. Install the rear wiring harness between the lights.
NOTE
30" extensions are required on each side on 30’
through 41’ models.
4. Install the main harness by starting at the hitch and
routing the harness through the hose loops to the
extension harness.
5. Insure the harnesses are clear of any moving parts
and secure the harnesses with tie wraps provided.