Sensaphone IMS-4000 Users manual - Manual (Page 32)

IMS-4000 Manual
30
baTTery CoMparTMenT
The battery compartment is located below the top panel. The unit requires (1) 6V 3.4AH rechargeable battery (included).
To remove or replace the battery, remove the top cover with a small flat-head screwdriver. {Note: Earlier versions of the
node used six (6) C-size 2000mAHr Ni-Cad batteries. These units can be identified by their black network jack or via soft-
ware—they will be running firmware version 2.xx or earlier.}
insTallaTion
This section provides information on:
• Operating environment
• Rack, wall, & tabletop installation
• Connecting sensors
• Replacing the battery
parts required
Phillips Screwdriver • 9 pin F/F null modem cable • Dumb terminal or PC w/9 pin com port
operaTinG enVironMenT
Before you install the IMS-4000 Node be sure that your operating environment meets the physical requirements of the
equipment.
Operating Temperature: 32º–122º Fahrenheit (0º–50º C)
Humidity: 5–90 %RH, non-condensing
Power: 120VAC 60 Hz outlet within 6'
Rack Requirements: Standard 19" equipment rack with supplied mounting bracket hardware. Requires 1.0 EIA
rack mount space.
Tabletop requirements: Flat area which can support an enclosure 10" wide by 8" deep by 2" high.