Sensaphone IMS-4000 Users manual - Manual (Page 59)

57
Chapter 2: IMS-4000 Software
alphanUMeriC paGer Calls
The unit can dial alphanumeric pagers to send alarm messages. The IMS-4000 uses industry standard TAP protocol, which
is supported by most pager systems. The IMS-4000 will send the type of alarm, the name of the Host or Node, the Input
name, the current value, the programmed high or limit, and the time of the alarm. To program an alphanumeric pager desti-
nation, enter the pager service data/modem phone number followed by the letter A and then the pager ID.
Example: (610)555-4500-A-0504099
Contact your pager company if you do not know the data/modem telephone number or the pager ID for your alphanumeric
pager.
If your paging provider requires a password, add it to the end of the dial string preceded by the letter c. An example is
shown below:
Format with a password
TAP terminal number + a + pager/telephone number + c + password
example: 18005551234a7775552222cpasswd
fax Calls
Enter the telephone number of the fax machine.
e-Mail
Enter the e-mail address.
snMp
Enter the SNMP server IP address in numeric form (e.g. 192.168.0.1)
sCheDUle
Click the Schedule button to bring up the Schedule screen for this Contact. Choose the times you want the Contact to be
enabled by adjusting the blue bars. Areas where the blue bar appears indicates the day and time the Contact is Enabled.
Figure 34: Contact Schedule screen
For example, the schedule above enables the contact Mon-Fri 8AM to 5PM.
Editing the schedule:
• Click on the All button in the top left corner of the grid to enable/disable the entire week.
• Click on the day buttons down the left side of the grid to enable/disable entire days
• Click on the hour buttons across the top of the grid to enable/disable entire hours
• Drag the mouse over portions of the grid to enable/disable specific hours/days
alarM DeliVery opTions
There are additional options which appear on the Contact Setup screen depending upon the type of call. For alarm delivery
you must select either Receives Unacknowledged Alarms or Receives Inform Only Alarms or both.
Receives Unacknowledged Alarms: This option applies only to voice and pager calls. When selected the IMS-4000 will call
this contact until the alarm has been acknowledged or until the number of call attempts has been exhausted. If the alarm is
acknowledged by another user, this contact will stop being called.