Sensaphone 1400 - Manual (Page 53)

Chapter 5: Communication Programming
51
DATE and TIME
The 1400 has an internal clock/calendar that is used to time-stamp
events and maintain alarm history. To program the date and time:
1. Press SET, followed by the DATE/TIME key.
2. The unit will say “Enter the date.” Enter the date in month/day/
year (mm/dd/yy) format using two digits for each. For example,
if the date was January 7, 2005 you would enter 010705, then
press ENTER.
3. Next, the unit will say “OK, enter the time.” Enter the time in
24-hour format (e.g. 3:00
pm
= 15:00) using hours/minutes (hh/
mm) format. For example, if the time was 1:30
pm
you would
enter 1330, then press ENTER.
4. To check the date and time press WHAT IS, followed by DATE/
TIME. The unit will announce the date and time.
NOTE: The internal clock is powered by an
onboard lithium battery which should provide 8–10
years of service life.
To program only the Date or only the Time, you can simply press
the ENTER key when prompted and the unit will keep its current
value. For example, to program a new TIME but keep the current
DATE, press [ENTER] when prompted for the Date. The unit will
keep the current setting and then prompt you to enter the new Time.