Sensaphone 1400 - Manual (Page 86)

Sensaphone 1400 Manual
84
REMOTE PROGRAMMING SECURITY CODE (LOCK)
The 1400 can be locked to prevent unauthorized call-in access to its
programming. You may, however, listen to a status report without
unlocking the 1400. To remotely edit programming parameters or
record messages, you must call in and unlock the 1400 by entering
the four-digit lock/unlock code.
If you enter the correct code, you will gain access to the 1400 to use
the phone commands. If you enter the incorrect code, the 1400 will
say “Error 2” and allow you a second chance to enter the correct
code. If the second attempt is also wrong, the unit will say “Error 2,
good-bye” and disconnect. You cannot program or change the lock
code remotely.
For an explanation of how to use remote programming, see Chapter
Seven.
To set the security code:
1. Press the SET key.
2. Press the LOCK key.
The 1400 will say “Enter security code.”
3. Using the number keys, enter 4 digits, and press ENTER.
The 1400 will say “OK.”