Sunnex PF Series (MRI) - Manual (Page 13)

Sunnex PF Series MRI Service & Installation Manual
13
SHOULD BE SECURED TO A STRUCTURAL MEMBER AT A SAFE
DISTANCE (100 GAUSS LINE) AWAY FROM THE MRI MACHINERY.
DO NOT MOUNT BOX DIRECTLY TO SHEET ROCK OR PLYWOOD
SUBSTRATES. IDEALLY, THE TRANSFORMER BOX IS SECURED BY
NON-FERROUS FASTENERS, DIRECTLY TO THE FLOOR/CEILING
OUTSIDE THE MAXIMUM RECOMMENDED GAUSS LINE.
5. OPERATING INSTRUCTIONS
While this light is MRI compatible and can be used as a medical task light
around the bore, it is extremely important that all guidelines are strictly
followed to ensure safety for users and patients.
• This light is only intended for use outside of the bore
• This product is not suitable for use in the presence of a FLAMMABLE
ANAESTHETIC MIXTURE WITH AIR or WITH OXYGEN OR NITROUS
OXIDE.
• The installation guidelines must be strictly followed. The electrical box
contains ferrous materials and must NEVER be placed close to the
magnet. If the electrical box is moved closer to the magnet at 100
gauss line, electromagnetic interference may be seen, to avoid this
NEVER move the electrical box close to the magnet.
•
NEVER operate the light while the electrical box is unsecured.
• The lamp may slightly vibrate during its operation, but it is absolutely
normal to the operation of the light.
• It is recommended that the light be operated 3 feet away from the bore
of the magnet, if the light is operated at the bore, it may reduce the bulb
life.
1. Position the light fixture conveniently to illuminate the target area
2. Position the lamp arm by adjusting the handles on the joints. The lamp
arm assembly has three knobs to adjust the position of the light. Once
a desired position is selected, tighten the three knobs properly to make
the light stable. The lamp head can be moved 315 degrees using the
handle on the lamp head.
3. Verify that the power cord is connected to the electrical box and the
electrical box is powered from the receptacle.