Sunnex PF Series (MRI) - Manual (Page 8)

Sunnex PF Series MRI Service & Installation Manual
8
1. Snap in five wheels onto caster base. It may be necessary to expand the
brass clip with a screwdriver to fit the wheel in caster base (See figure 1).
Take 5/16 -18 bolt (provided) and position bolt up through the weight and
bottom of caster base. Attach caster base and weight to pole by threading
screw into the bottom of the pole. Ensure that the weight, caster and
vertical pole are attached properly.
Figure 1. Installing counter weight to the caster base
2. Place lamp arm assembly into top of pole and secure in position with the
set screw provided in the side of the pole.
ELECTRICAL CONNECTIONS
Option 1 – Installing the transformer box outside MRI room using RF
filter
The transformer box is equipped with 30ft of cord on the secondary side and
10ft of cord on the primary side. If installing the transformer box outside the
MRI room, connectors may be required on the secondary side to
Counter
Weight
Caster
Base
Wheels
Brass
Clip