Rockwell Automation 1420 PowerMonitor 500 - Manual (Page 13)

Rockwell Automation Publication 1420-UM001D-EN-P - September 2013
13
PowerMonitor 500 Overview
Chapter 1
Display Icons
9. Indicates that the metering values displayed are system (three-phase)
values.
10. Indicates a phase sequence error alarm.
11. Configuration lock switch is not active. Always indicates unlocked.
12. Indication of serial RS-485/RS-232 data transmission (TX) and reception
(RX).
Alarm Icons
• Indicates a high value alarm
• Indicates a low value alarm
Selecting Data to Display The table below provides a guide to navigation through the metering data
displays available on the front panel display.
To access information pages, press and hold for more than 2 seconds,
then press and to select information items, as shown in Table 2 .
Information items are not displayed for options that are not installed.
9
10
11
12
Table 1 - Navigation
No. Line 1 Line 2 Line 3 Line 4 Line 5 Note
Press the
key
for <2
seconds 0 Home page Programmable
1 Total kWh (+) Depending on the last displayed page of
instantaneous variables.
2 Total kVARh
(+)
3 kWh (+) part.
4 kVARh (+)
part.
5 Run Hours
(99999999.99)
Press the
key
for <2
seconds 6 Phase seq. VLN

VL1 VL2 VL3
7 Phase seq. VLN

VL1-2 VL2-3 VL3-1
8 Phase seq. An AL1 AL2 AL3
9 Phase seq. Hz - - -
10 Phase seq. VA

VA L1 VA L2 VA L3
11 Phase seq. var

var L1 var L2 var L3
12 Phase seq. W

WL1 WL2 WL3
13 Phase seq. PF

PF L1 PF L2 PF L3