Rockwell Automation 1734-ADNX POINT I/O DeviceNet Adpater User Manual - Manual (Page 22)

Publication 1734-UM002C-EN-P - July 2003
2-2 What is the 1734-ADN(X) Adapter?
Using the Adapter The adapter resides on the primary DeviceNet network and the
Subnet simultaneously.
From this position, the adapter interfaces between DeviceNet devices
and POINT I/O modules. The graphic below shows the adapter on
the DeviceNet network and PointBus.
After you have installed your adapter into a POINT I/O system, you
must perform the following tasks:
1. Set Subnet/Backplane Baudrate
2. Set Subnet I/O Module Addresses
3. Configure the Subnet I/O
4. Configure the Primary DeviceNet Network
The steps mentioned above are explained briefly here and then in
greater detail throughout this manual. You must complete the steps for
the adapter to work with DeviceNet masters (e.g., 1756-DNB) on the
primary network and Subnet modules.
IMPORTANT
The PointBus maintains all DeviceNet network
protocol but also offers configuration capabilities.
System
Field
1734-EP24DC
Power
Power
6 3
1734-ADN
Module Status
DeviceNet Status DeviceBus Status
computer with PLC
programming software
ControlNet network
PLC-5 processor
1784-PCD
PCMCIA card
1734-ADN adapter
DeviceNet network
computer with
RSNetWorx for
DeviceNet software
POINT I/O modules
42407
Subnet (1734-ADNX only)