Rockwell Automation 1734-ADNX POINT I/O DeviceNet Adpater User Manual - Manual (Page 62)

Publication 1734-UM002C-EN-P - July 2003
4-4 Configuring the 1734-ADN(X) Adapter’s SubNet
You will see a pop-up screen with a series of tabs. Each tab provides
options to write configuration for your adapter. The tabs are shown
below and on the following pages.
Type the scanner’s name here.
Type a description here.
The scanner’s address must = 0.
This screen also shows the
scanner’s device identity.
These fields are read-only.
Use Associate File to
associate this configuration
file (i.e., configuring the
1734-ADN for communication
with POINT I/O modules) with
the configuration file that
configures the same
1734-ADN for communication
with a master device on the
primary DeviceNet network.
For more information on the
need to maintain two
configuration files in the same
adapter, and the simultaneous
presence of the adapter on
two networks (i.e., DeviceNet
as a slave and PointBus as a
master), see page 5-1.
At any point, you can click here to finish
changing configuration parameters.
IMPORTANT: Configuration changes made
in offline mode do not take
effect until the scanner goes
online. For more information
on how the scanner goes
online, see page 4-8.
Use Clear Association to remove
previously established configuration
file associations that no longer apply
to your adapter.