Adding the scanner to your network – Rockwell Automation 1734-ADNX POINT I/O DeviceNet Adpater User Manual User Manual
Page 60
Advertising
Publication 1734-UM002C-EN-P - July 2003
4-2 Configuring the 1734-ADN(X) Adapter’s SubNet
You must follow these steps during configuration:
1. Adding the Scanner to Your Network
2. Adding I/O Modules to Your Network
3. Setting the Scanner’s Parameters
4. Going Online
Adding the Scanner to Your Network
Follow these steps:
1. Start RSNetWorx for DeviceNet.
2. Add the scanner as shown below.
1. Expand the list of
communication adapters.
2. Expand the 1734-ADN POINT
I/O Scanner field.
The scanner appears
on the network.
IMPORTANT
The adapter must always exist on the Subnet at Node
00.
Advertising
This manual is related to the following products: