Rockwell Automation 1734-ADNX POINT I/O DeviceNet Adpater User Manual - Manual (Page 96)

Publication 1734-UM002C-EN-P - July 2003
B-16 1734-ADNX Quick Start
6. From the RSNetWorx for DeviceNet main menu, select
File>Save As.
7. Type in SubNet as the filename.
8. Click Save.
9. Verify your screen appears as shown below.
On the Subnet, the 1734-ADNX is a scanner and it is always at
node 0. It is OK for some or all of the node numbers on the
Subnet to be the same as devices on the primary network.
Because they are two different networks, duplicate node errors
will not occur. The 1734-ADNX will communicate back to the
1756-DNB scanner as a single entity (only taking up one node
number on the main network).
10. To view the configuration you just created, Upload the scanlist
from the 1734-ADNX. Double click on the 1734-ADNX to bring
up its properties page.
11. Select the scanlist tab and when prompted select Upload.
IMPORTANT
You must save your work before continuing.
The nodes can be in any order. Verify:
• All five are there
• They have the correct node numbers