Rockwell Automation 1746-NI8 SLC 500 Analog Input Modules User Manual - Manual (Page 15)

Chapter
2
Publication 1746Ć6.8 - April 1997
Quick Start
for Experienced Users
This chapter can help you to get started using the 1746-NI8 analog
input module. We base the procedures here on the assumption that
you have an understanding of SLC 500 products. You should
understand electronic process control and be able to interpret the
ladder logic instructions required to generate the electronic signals
that control your application.
Because it is a start-up guide for experienced users, this chapter does
not contain detailed explanations about the procedures listed. It
does, however, reference other chapters in this book where you can
get more information about applying the procedures described in
each step. It also references other documentation that may be helpful
if you are unfamiliar with programming techniques or system
installation requirements.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the
referenced chapters and other recommended documentation before
trying to apply the information.
This chapter will:
•
tell you what equipment you need
•
explain how to install and wire the module
•
show you how to set up one channel for analog input
•
examine the state of the LEDs at normal startup
•
examine the channel status word
Have the following tools and equipment ready:
•
medium blade screwdriver
•
medium cross-head screwdriver
•
analog input device
•
cable for wiring inputs to module
•
SLC processor and power supply installed in chassis
•
analog input module (1746-NI8)
•
programming device and software
Required Tools and
Equipment