Rockwell Automation 1746-NI8 SLC 500 Analog Input Modules User Manual - Manual (Page 89)

Index I–3
input image, 2-6
See also status word and data word
definition, G-2
input response to slot disabling, 4-6
input specifications, A-2
input types, A-2
installation, 3-1, 3-5
equipment required, 2-1
getting started, 2-1
heat and noise considerations, 3-3
location in chassis, 2-3, 3-2
L
LEDs, 1-2
channel status indicators, 1-2
module status indicator, 1-2
state tables, 7-2
local configuration, definition, G-2
LSB, 5-6
definition, G-2
M
memory map, 4-2, 4-3
module ID code, 2-4, 4-1, C-1
how to enter, 2-4, 4-1, C-1
module operation, 1-4
module scan time
definition, G-2
minimizing, 5-4
response to open circuit, 5-4
module status LED, 2-6
module update time
calculating, 4-5
definition, G-2
for number of channels enabled, 4-5
increased by reconfiguration, 5-4
multiplexer, definition, G-2
multiplexing, 1 -4
N
negative decimal values, D-2
noise filtering,
4-7
normal mode rejection, definition, G-3
O
open-circuit, 7-3
defining conditional state of channel data,
5 -3
downscale enable, 5-3
upscale enable, 5-3
zero, 5-3
error condition, 7-3
fault detection bit, 5-14
module response to, 5-4, 5-13
operation
module, 1-4
system, 1-3
out-of-range error, 7-3
over-range error, 5-14
under-range error, 5-14
output image, 2-5, 4-3
definition, G-3
output response to slot disabling, 4-6
over-range error,
5-14
fault indicator bit, 5-14
P
physical specifications, A-1
PID input type, 5-6
PID instruction, 6-3
pinout diagram, 3-6
Positive Decimal Values, D-1
power requirements, 3-1
power-up sequence,
1-3
programming
alarms, 6-4
configuration settings, 2-5, 6-1
initial setting, 6-1
PID instruction, 6-3
proportional counts input, 5-6
R
reconfiguration time, 4-6
remote configuration, definition, G-3
removable terminal block,
1-2
removing the module, 3-4
resolution, definition,
G-3