Rockwell Automation 1747-AENTR SLC 500 EtherNet/IP Adapter User Manual User Manual
Page 15
Rockwell Automation Publication 1747-UM076C-EN-E - January 2013
9
Install Your Adapter Chapter 2
Refer to the Industrial Controller Wiring and Grounding Guidelines publication
for proper grounding and wiring methods to use when installing your
module.
1. Remove power from the I/O chassis before inserting (or removing) the
module.
2. Align the circuit board with the chassis card guide in the left slot.
3. Install the module in slot 0 of the chassis by aligning the circuit board with
the chassis card guide.
The 1747-AENTR module must be installed only in slot 0 (leftmost
slot)of the chassis.
4. Press firmly and evenly to seat the module in its backplane connectors. To
remove the module, press the releases at the top and bottom of the module
and pull it out.
Connect Your Adapter to the
Ethernet/IP Network
through RJ-45 Connection
Connect your 1747-AENTR adapter module to an Ethernet/IP network as
shown below:
ATTENTION: Do not force the module into the backplane connector. If
you cannot seat the module with firm pressure, check the alignment.
Forcing the module can damage the backplane connector or the module.