Rockwell Automation 1203-USB Converter - Manual (Page 33)

PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
Chapter 3
Configuring the Converter
This chapter provides instructions and information for setting the
parameters to configure the 1203-USB converter.
For a list of parameters, see the following sections:
•
Parameters – DPI Drives on page B-1
•
Parameters – DSI Drives on page B-2
•
Parameters – SCANport Drives (DriveExplorer or DriveExecutive
software only) on page B-4
For definitions of terms in this chapter, see the Glossary .
Configuration Tools
The 1203-USB converter stores parameters and other information in its own
nonvolatile storage (NVS) memory. You must, therefore, access the
converter to view and edit its parameters. The following tools can be used to
access the converter parameters.
Important: The RS-485 serial port on DSI drives does not need to be
configured before using the converter. DSI communications are
configured automatically (19.2K baud and 8-N-1).
Topic Page
Configuration Tools 3-1
Using Connected Components Workbench Software 3-2
Resetting the Converter 3-7
Updating the Firmware 3-8
Using RTU Master Mode for a Serial Multi-drop Network 3-8
Tool Page
Connected Components Workbench Software, version 1.02 or later 3-2
DriveExplorer Software, version 4.04 or later C-1
DriveExecutive Software, version 1.01 or later D-1
Terminal Emulation Software (such as HyperTerminal) E-1