Rockwell Automation 1203-USB Converter - Manual (Page 91)

PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
Appendix E
Use with HyperTerminal Software
This appendix presents information about using HyperTerminal software
with the 1203-USB converter.
Configuring the Converter
This section provides detailed instructions on how to use terminal emulation
software to access the 1203-USB converter so that you can view and edit its
parameters or view its event queue.
A variety of terminal emulation programs can be used to establish a USB
connection between a computer and the converter. The following
instructions describe how to establish the initial USB connection to the
converter using a computer running HyperTerminal—terminal emulation
software provided with most Windows operating systems.
Important: The following instructions use example images from Windows
XP HyperTerminal software. If you are using a different
operating system, the images may differ.
1. Obtain and note the COM port that was assigned during installation of
the 1203-USB driver by doing the following.
a. Open the Windows Control Panel and double-click System.
b. In the System Properties window, click the Hardware tab.
c. Click Device Manager.
Topic Page
Configuring the Converter E-1
Resetting the Converter E-4
Preparing for a Firmware Update E-5
Updating Firmware E-5
Troubleshooting E-6
TIP: The Windows 7 operating system does not come with HyperTerminal
software. An alternative telnet software will have to be used.