Rockwell Automation 1203-USB Converter - Manual (Page 39)

Configuring the Converter 3-7
PowerFlex 1203-USB Converter User Manual
Publication DRIVES-UM001D-EN-P
21. To edit a parameter, either make the changes directly in the grid or
double-click the parameter to open a parameter editor window.
22. Close the window when finished.
Resetting the Converter
Changes to settings of some 1203-USB converter parameters require that
you reset the converter before the new settings take effect. You can reset the
converter by cycling power to the drive or by using converter Parameter 02
- [Reset Module].
Set converter Parameter 02 - [Reset Module] to ‘1’ (Reset Module).
When you enter ‘1’ (Reset Module), the converter will be immediately
reset. When you enter ‘2’ (Set Defaults), the converter will set all converter
parameters to their factory-default values. After performing a Set Defaults,
you must enter ‘1’ (Reset Module) or power cycle the converter so that the
new values take effect. Thereafter, this parameter will be restored to a value
of ‘0’ (Ready).
!
ATTENTION: Risk of injury or equipment damage exists. If the
converter is transmitting control I/O to the drive (indicated by a
solid green diamond LED), the drive may fault when you remove
or reset the converter. Determine how your drive will respond
before removing or resetting a connected converter.